DataCard SP75 Plus Guia de Instalação descarregar pdf (Página 49)

Page 44

Set the Laminator Heater Temperature

All SP75 printers have an L1 laminator and the Configuration Menu includes a Laminator 1 choice. Some SP75

printers also have an L2 laminator and include a Laminator 2 choice. Displays in this guide show Laminator 1.

Change the heater temperature only when troubleshooting or when your service provider instructs you to do so.

See Troubleshooting in SP Series Info Central for information about card appearance problems.

1 With “Configuration” displayed on line 1, press the Up or Down Arrow key if

needed to display “Laminator 1” or “Laminator 2” on line 2.

2 Press the Enter key. “Heater Temp” appears line 2.

3 Press the Enter key to display the currently defined operating temperature (in

degrees Celsius (C)) for the material.

4 Press the Up or Down Arrow key to change the Heater Temp setting. Change the

temperature a few degrees at most.

5 When the Heater Temp reaches the level you want, press the Enter key to return to

the Configuration menu. “Exit” appears on line 2.

6 To print cards, press the Enter key repeatedly to return to the “Printer Ready” display.

7 Print a card to observe the result.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 135 136

Sem comentários

DataCard SP75 Plus Guia de Instalação Página 49