DataCard SR300 Manual do Utilizador descarregar pdf (Página 17)

SR200 & SR300 Printer SDK Guide

Page 13

Functions for Moving and Discharging the Card

The API provides the following functions to move and discharge the card:

♦ Card Load Function

♦ Card Move Function

Card Load Function

No. Function Name Explanation

1 int CXCMD_LoadCard

(int iSlot, int iID,

int iDest,

int iFlip,

int iFilmInit,

int iImmed)

Pick a card and move it to the specified position.

iDest Destination to move card.

0 Retransfer position

1 Contact IC encoder

2 No-contact IC encoder

3 MG encoder

4 NG Card outlet. Discharges the card from NG card

outlet (on the right side of the printer).

iFlip Specify whether turn over the card.

0 Do not turn the card over

1 Turn over the card before arriving at the destination

iFilmInit Specify whether to move the retransfer film. This

setting is effective only when iDest is 4 (NG Card outlet).

0 Not adjusted

1 Adjusted

iImmed The immediate flag specifies when the printer

replies.

0 Reply after printer finishes printing.

1 Reply immediately after printer accepts the command.

Tips for success

♦ If the retransfer film is printed on but not used, set iFilmInit to 1 to move the

printed area of the retransfer film.

♦ The printer returns an error if CXCMD_LoadCard() is used when there is a

card in the printer.

♦ The printer returns a positive value if CXCMD_LoadCard() is issued while the

printer is moving a card or the retransfer film. See Return Codes from

Functions for return values.

♦ If the function returns a positive value, wait and retry the function.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Sem comentários

DataCard SR300 Manual do Utilizador Página 17