DataCard SR300 Manual do Utilizador descarregar pdf (Página 41)

SR200 & SR300 Printer SDK Guide

Page 37

Laminator Unit Data (Page Code=0x2C)

Bit

Byte

7 6 5 4 3 2 1 0

0 0 Page Code (0x2c)

Page Specific Parameter Length (0x16)

Laminate Mode

Film T Type

Film T Position

Heat Roller T Temp

Laminate Speed

Reserved (0xff)

Laminate Cooling Time

HR Control

10-13

Reserved (0xff)

Film B Type

Film B Position

Heat Roller B Temp

17-23

Reserved (0xff)

Tips for success

♦ Laminator settings are saved in the laminator EEPROM (memory).

♦ The printer ignores settings for a laminator that is not connected.

♦ If you set a value to 0xff, the current setting in the laminator is used.

♦ The T side is the top side of the card as it enters the laminator. The B side is

the opposite side of the card.

♦ The Film T Type and Film B Type settings take effect after the laminator is

reset. All other settings take effect with the next card.

Laminate Mode The type of lamination process used.

0 Laminate 1 Pass through

Film T Type The type of lamination film on the top side. Reset the laminator to

make the new setting take effect.

0 Patch 1 Overlay

NOTE: The LM300 laminator is designed to use same type of film in the top

and bottom laminators. Using different types of film is not guaranteed.

Film T Position The position of lamination start (± X direction) on the top side. The

possible range is from 0 (-7) to 14 (+7).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 75 76

Sem comentários

DataCard SR300 Manual do Utilizador Página 41