DataCard LM200 Guia do Utilizador descarregar pdf (Página 27)

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 17

Loading Top-Side Laminate Film

1. Openthelaminatordoorbypullingthetopofthedoortowardyou.

2. Removethetop‐sidefilmcartridge:

Pressthelaminatorcartridgereleasebuttonandremove

thelaminatorcartridgecarefully.Thelaminatematerial

mustbetightwhenremovingthecartridge.

3. Removetheusedmaterial(ifpresent).

Besuretosave

theemptysupplyspool.(Donotthrowit

away.)Usetheemptyspoolasthetak e‐upspoolinstep 4

ofthisprocedure.

4. Placethenewrollofmaterialnexttotheemptytak e‐upspoolonacleansurface.

5. Removethelabelfromthelaminatematerialanduseitto



securethefreeendofthematerialtotheemptytak e‐up

spool,makingsurethattheedgesareeven.

6. Loadthenewrollofmaterialonthecartridge:

a. Putthefullrollofmaterialonthesupplyspindle.

b. Puttheemptytak e‐upspoolonthetake‐upspindle.

Alignthematerialalongthefourmetalguidesas

shownonthecartridgelabel.

d. Windtwoorthreerotationsoffilmontothetake‐up

spool.Takeupslackbetweenthespoolsbyturningthe

supplyknobclockwise.Ifslackcannotberemoved,verify

thatthesupplyandtake‐upspools

arefirmlyseatedon

thespindles.

7. Replacetheloadedlaminatorcartridgeinthelaminatoruntilitclicksintoposition.

8. Closethelaminatordoor.

9. Iftheloadingstatusofthecartridgeischanged

whenchangingthesidetobelaminated,the

laminatordoesnotinitializewhenthelaminator

dooris closed.

PresstheOperatorbuttontoinitialize

thelaminator.

OperatorButton

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 137 138

Sem comentários

DataCard LM200 Guia do Utilizador Página 27