DataCard LM200 Guia do Utilizador descarregar pdf (Página 76)

66 Printer and Laminator Settings

Applying a Second Retransfer Layer

Toincreasethedurabilityofacard,youmaywanttoapplyasecondretransferlayertothefront

and/orbackofthecardduringprinting.UsetheLCDpanelmenustochangetheprintersettings

toperformthisprocess.

1. StartwiththeprinteronandtheLCDpanelindicatingReady.Press

theMenuandcenterkeyssimultaneouslyforseveralseconds.

2. Rele ase theMenukeyfirsttoplacetheprinterinmaintenance

mode.

3. PressEnteronce.TheOffsetPrtYmenudisplays.

4. PressNext13timestodisplaytheOvercoatmenu.

5. PressEntertodisplaytheMode(Front)menu.

Toapplyanadditionalretransferlayertothefrontofthecard,press

Change.

6. PressthedownarrowkeyoncetochangeLine2toOnandthen

press(Return)toacceptthechange.

7. PressNexttocontinue.

Donotplantoapplyasecondretransferlayertoacardifithasamagneticstripe,

signaturepanel,hologram,orsmartcardchip.

Whenyouusepeel‐offribbononthecardbecauseithasamagneticstripe,signature

panel,hologram,orsmartcardchip,thesecondretransferlayer

isnotapplied.The

printerdoesnotprovideanotificationthatthesecondlayerisnotbeingapplied.

Makesurethatyouarefamiliarwithyourcarddesignbeforeproceedingwiththe

followingsteps.

13X

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 137 138

Sem comentários

DataCard LM200 Guia do Utilizador Página 76