DataCard LM200 Guia do Utilizador descarregar pdf (Página 87)

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 77

Cleaning the Internal Components

Dirtintroducedduringcardfeedorburrscausedbyfrictionbetweenthebobbinholderand

bobbincanadheretothecardorfilm,causingcardlaminationdefects.Cleanthes ecomponents

regularlytoavoidlaminationdefects.

1. Poweroffthelaminator.

2. Openthelaminatordoor.

3. Pre ssandholddownthecartridgereleasebutton

andpulloutthetoplaminatefilmcartridge

(LM200only)andthebottomlaminatefilmcartridge.

4. UseaDatacard®printheadcleaningswab(providedintheCleaningKit.Referto“Cleaning

Supplies”onpage 109)tocleanthefollowingcomponents:

a. Bobbinholders:

twoforeachfi lmcartridge

b. Rearguiderails,oneach

sideoftheheat

roller.Cleanupperandlowersurfaces.

c. Frontguiderails,oneachsideoftheheat

roller.Cleanupperandlowersurfaces.

5. Removeanyslackinthecartridges.

6. Reinstallboththetopandbottomfilmcartridges

inthelaminator.

7. Closethelaminatordoor.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 137 138

Sem comentários

DataCard LM200 Guia do Utilizador Página 87