DataCard LM200 Guia do Utilizador descarregar pdf (Página 84)

74 Maintaining Your Printer and Laminator

15. Aftercleaning,thecardisdischargedandCleaningStartOK?

isdisplayed.Press ,turnthecardover,andinsertit

againtocompletethecleaningprocess.

16. Whenthecardisdischarged,pressExittoendtheprocess.

17. Whenthecleaningcardisdischarged,powerofftheprinter.

Waitten

secondsandthenreinstalltheretransferfilm

cartridge,cardhopper,andlaminatorfilmcartridges,and

powerbackon.

Cleaning the Magnetic Head

Clean the magnetic head after every 1,000 cards when you are printing magnetic stripe cards.If

youarenotusingmagneticstripecards,themagneticheaddoesnotrequirecleaning.

1. Poweroffboththeprinterandlaminator(ifinstalled).

2. Powerontheprinter.

3. Movethelaminator(ifinstalled)awa yfromtheprintertoavoidacardjamduringthe

cleaningprocess.

4. Removethecardhopper.

5. PresstheMenukey.Cleaningisdisplayed.

6. PressEnterandusetheNextkeytoselectMGOK?

7. Placethreeorfourdropsofisopropanolonthestripeofthemagnetic

headcleaningcard.

8. Press(Return)ontheLCDpanel.

9. Placethemagneticheadcleaningcard(stripeside

up)on

thecardloadroller.Thecardisdrawninto

theprinterbytherollersandcleaningbegins.

10. Whenthecleaningcardisdischarged:

a. Powerofftheprinter.

b. Replacethecardhopper.

c. Waittenseconds.

d. Powerontheprinter.

CleaningCardDischarged

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 137 138

Sem comentários

DataCard LM200 Guia do Utilizador Página 84