DataCard UltraGrafix Select Manual de Instalação descarregar pdf (Página 212)

200 Hex Dump

Perform the following steps to use the Hex Dump tool:

1. Select Application | Utilities | Hex Dump.

2. Select a Data File to view by clicking Browse and then navigating to the file’s

location. The data for the selected file will appear in the display.

3. Optionally select a corresponding Data Setup (whose encoding you would

like to use to convert the data file selected) by clicking Browse and then

selecting an available Data Setup from the list.

4. Select a format option.

• Blocks - Fixed size portions of a file. The size to display can be configured

by selecting the block size from the list. You can browse through the block

using the navigator at the bottom of the window.

• Records - Only available if a Data Setup is selected. The file is displayed

by record. You can select Record Length or Record Delimiter if these are

defined in the Data Setup. You can browse through the records using the

navigator at the bottom of the window.

5. Select an Offset option.

• Absolute - Offset relative to the beginning of the file.

• Relative - Offset relative to the beginning of the block or record.

6. If desired select option to Only Display Latin-1 Characters.

7. If desired click Toggle Grid Lines to toggle-on grid lines in the table, click

again to toggle-off.

8. Navigate through the data using the Job and Record number (if available)

navigation buttons located at the bottom of the screen. You can navigate by

job, single record, 10 records at a time, or the beginning or end of a job. The

Record Type, Record Length and Product Number are displayed on the

bottom right of the Hex Dump screen.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 321 322

Sem comentários

DataCard UltraGrafix Select Manual de Instalação Página 212