DataCard UltraGrafix Select Manual de Instalação descarregar pdf (Página 295)

Maxsys and MX Series Software Administrator’s Guide 283

Vector Beziér Spline Element

Use this tab to define coordinates for all four points of the spline. The

combination of the coordinates determine the length and depth of the curve. Note

that the Beziér spines used by ConCAD are cubic Beziérs.

Vector Text Element

Ellipse Rotation The ellipse radius can be defined along the x and y

position. That means an ellipse can be defined that is

either lying (x-radius > y radius) or standing (y-radius > x-

radius). To draw ellipses that have the semi-major/semi-

minor axis in different directions than the x/y axes, the

ellipse can be rotated.

Rotation is in mathematical direction (positive angle:

counterclockwise; negative: clockwise).

Start Angle The position, given in degrees as a direction from the

center point, where the ellipse begins.

Angle direction is given mathematically (i.e. 0° = 3

o'clock, positive values = counterclockwise).

Processing Angle The length of the circular arc in degrees beginning at the

start angle. 360° is a full circle, 90° a quarter circle.

Processing angle is given in mathematical direction (i.e.

positive degree values = counterclockwise; negative

values are clockwise).

Read Only

Properties

Start and end points for each axis.

Start Point Location (x/y coordinates) of the starting point.

Control Points (1

and 2)

The position of the control points along the curve.

End Point Location (x/y coordinates) of the end point.

Note: The line drawn will not go through the control points

unless the line is straight.

Arc Length Read only, arc length in mm.

Alignment Point Location (x/y coordinates) of the text string with

respect to the layout.

Text Alignment Alignment (x/y axis) of the text string.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 321 322

Sem comentários

DataCard UltraGrafix Select Manual de Instalação Página 295