DataCard UltraGrafix Select Manual de Instalação descarregar pdf (Página 227)

Maxsys and MX Series Software Administrator’s Guide 215

Chapter 17: Back Up and

Restore

This chapter contains information on backing up and restoring a

Maxsys/MX Series system.

Backing Up and Restoring the System

After the controller software is installed, prepare a backup of the hard drive(s) so

that recovery is possible. Then if the software is changed, more software is added,

or setups on the drive are modified, the hard disk(s) should be backed up again.

New systems ship with a CD containing Acronis software to perform the backup.

Before beginning a backup, make sure the system is as clean as possible. Purge

any event logs or trace files to lower the size of the image and decrease the time

needed to backup and restore. If data is present that is not needed by you or the

customer, drop the database tables as described below. For security reasons do

not make a backup of the system with customer data loaded, unless requested to

do so by the customer.

Dropping Unnecessary Database Tables

Delete unnecessary tables before a backup (or if the Controller database gets

corrupted and will not allow the user interface to start up). Use the following

procedure to drop the database tables.

1. Navigate to Programs | IBM DB2 | DB2COPY1 | General Administration

Tools | Control Center.

2. If a Control Center View dialog box is displayed, select Advanced option and

click OK.

3. From the left pane select All Databases | Maxsys | Tables.

4. On the upper right pane select Schema, which will sort the database tables

list.

5. Select the tables with Schema Maxsys; you can use the shift key to select a

range in the list.

6. Right-click and select Drop.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 321 322

Sem comentários

DataCard UltraGrafix Select Manual de Instalação Página 227