DataCard LM200 Guia do Utilizador descarregar pdf (Página 13)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide

Using the printer

This section describes how to perform basic tasks required to operate the

Datacard®

SR200 & SR300 printer and the Datacard® LM200 & LM300

card laminator. It describes how to:

Load supplies

• “Load cards” on page 8

• “Load ink ribbon” on page 10

• “Load retransfer film” on page 11

• “Load top side laminate film” on page 12

• “Load bottom side laminate film” on page 13

Power on

• “Check the PC connection” on page 14

• “Optional laminator connection” on page 15

• “Power on the laminator” on page 15

Prepare to print cards

• “Initialize the ink ribbon and retransfer film” on page 17

Print cards

• “Print cards using ID software” on page 18

• “Print from a PC application” on page 18

• “Tips for Success” on page 19

Before You Begin

• Begin with the printer and laminator set up and the printer driver installed. This

printer must be installed by Datacard authorized and trained personnel. If the printer

is not set up, contact your service provider.

• Set up the card design(s) to use, and test before beginning production. Be sure to

use production card stock, all data, and all processes. For example:

— Encode and read magnetic stripe data.

— Print and verify the colors and quality of printing.

— Laminate cards, if used, and make sure it meets your requirements.

• Ask your service provider for assistance, if needed, to make your design work.

If the printer uses the Security Lock, see “Security Lock tab” on

page 40. Unlock the printer before starting any of the tasks in

this chapter.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 108 109

Sem comentários

DataCard LM200 Guia do Utilizador Página 13