DataCard LM200 Guia do Utilizador descarregar pdf (Página 17)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 11

Load retransfer film

1 Slide the door latch up and

open the printer door.

2 Press the retransfer film

cartridge eject button and

remove the green cartridge.

3 Remove both used film

spools from the cartridge (if

present).

4 Load the new roll of retransfer

film on the cartridge:

a Put the full roll of film on

the green supply spindle

as shown (A).

b Put the empty take-up

spool on the black take-up

spindle (B).

c Align the retransfer film

along the three film

guides.

d Wind two frames of film

onto the take-up spool.

e Take up slack by turning

the take-up knob

clockwise. Gently pull

the take-up knob and

turn. If slack cannot be

removed, check that the

supply and take-up

spools are firmly seated

on the spindles.

To ease inserting into

the printer, the film must be

tight along the film guides.

Turning the supply and

take-up knobs will help

maintain the proper tension.

5 Replace the loaded retransfer

film cartridge in the printer until

it clicks into position.

6 Close the printer door.

1

2

E

6

5

Tips: Handling retransfer film

• Place the cartridge on a

smooth level surface when

loading or reloading.

• Do not place the cartridge

on the printer door to

prevent damage to the

door.

• Do not touch the printing

surface of the retransfer

film. (Oils on hands will

reduce printing quality.)

• Always initialize the

retransfer film after

powering on the printer.

See “Initialize the ink ribbon

and retransfer film” on

page 17 for more

information.

• Keep unused film in the

original package.

• Do not place film on a dusty

or dirty surface — dirt can

affect print quality.

• When the retransfer film

has run out, “Media Run

Out” appears on the LCD

panel. After replacing it,

press the Reset key and

then the Enter key to

initialize the film.

• The retransfer film cartridge

cannot be replaced in a

printer that is in Transport

Mode. Power the printer on

to cancel Transport Mode.

• See “Retransfer film” on

page 88 for more

information about retransfer

film.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 108 109

Comentários a estes Manuais

Sem comentários