DataCard LM200 Guia do Utilizador descarregar pdf (Página 23)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 17

Prepare to print cards

Initialize the ink ribbon and retransfer film

1 Press the Reset key on the control

panel.

2 The LCD display reads "Initialize OK?"

3 Use the Next key to select "2'nd Panel,

OK?" or "Next Panel, OK?"

— Press the Enter key when "Initialize

OK?" is displayed to initialize the

printer without winding the ribbon.

— Press the Enter key when "2’nd

panel, OK" is displayed and the

printer winds the ribbon and film

two panel sets.

— Press the Enter key when "Next

Panel, OK?" is displayed and the

printer winds the ribbon one panel

set and the film one panel.

Printing cards

Print cards after installing the printer and driver, and after setting up your

card design. See “Before You Begin” on page 7.

Cards can be sent from ID software such as Datacard

ID Works

identification software. ID software handles the types of information used on

cards.

If you do not have ID software, you can use another PC application to format

the information to print on cards; however, most PC applications do not

support magnetic stripe encoding or smart card programming. With any

application, test the card design to verify the results.

The printer’s LCD panel displays the following sequence when a card is sent

to print:

Tips – Printing

• The “Print” check box in

the Print tab of

Preferences must be

checked to print cards.

• During the printing

operation, do not open

the printer or optional

laminator door.

• Do not power off the

printer, laminator, or PC

during the printing or

laminating process.

• Do not unplug the printer

or optional laminator

during printing or

laminating.

• On the PC, do not use

the hibernate or standby

modes. If the PC powers

down while a card is in

the printer, it can stop

processing and remain

in the printer.

Tips – Initialize supplies

• One initialize action

moves both ink ribbon

and retransfer film.

• To avoid dirt and dust

particles that might

adhere to the ink ribbon

and retransfer film during

loading, move (initialize)

the supplies one panel

set each time a cartridge

is removed from the

printer and replaced.

• The printer detects the

type of ink ribbon and

retransfer film installed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 108 109

Comentários a estes Manuais

Sem comentários

DataCard LM200 Guia do Utilizador Página 23

Comentários a estes Manuais