DataCard LM200 Guia do Utilizador descarregar pdf (Página 88)

82 SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide

Patch Position

The position of the patch on the card can very slightly with a different lot of

laminator supply material. You can change the left-to-right position or the top

to bottom position.

Change the front-to-back position

Turning the supply sprocket of the film cartridge enables you to adjust the

patch position to the front or back by 1.0 mm.

Use the following steps to change the front-to-back patch position:

1 Power off the laminator and allow it to cool.

2 Open the laminator door and remove the laminator cartridge.

3 Remove the supply film from the cartridge.

4 Pull the

sprocket up.

5 Turn the

sprocket knob

to move the

patch:

— Turn the

knob counter-clockwise (+) to move the

patch position to the back.

— Turn the knob clockwise (-) to move the

patch position to the front.

6 Release the sprocket.

7 Load the supply film onto the cartridge.

8 Insert the cartridge, close the door, and power

on the laminator. The laminator initializes the

supply material automatically.

9 Laminate a card to verify the new position.

Change the left-to-right position

Use the Status Monitor to change the left-to-right position of the patch on the

card. See “Status Monitor” on page 31 to use the Film Position setting.

Use the following steps to change the left-to-right patch position:

1 Open the Status Monitor and select the Laminator tab.

2 Move the slider in the Position box to adjust the patch position left or

right.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 108 109

Sem comentários

DataCard LM200 Guia do Utilizador Página 88