DataCard LM200 Guia do Utilizador descarregar pdf (Página 40)

34 SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide

Printer Setting tab

The Printer Setting tab shows:

• Controls for viewing or changing print settings:

— YMC Ink Print Level, which sets the print

density for color printing.

Choose from

seven gradations from -3 (lighter) to +3

(darker).

— Resin K Ink Print Level, which sets the K

resin ink print density.

Choose from seven

gradations from -3 (lighter) to +3 (darker).

— UV Ink Print Level. Choose from seven

gradations from -3 (lighter) to +3 (darker).

— Peel Off Ink Print Level. Choose from seven

gradations from -3 (lighter) to +3 (darker).

— Resin K Ink Print Mode which sets the K resin ink print quality. If Fine is

selected, the print quality improves but the printing speed is slower.

Change

to Fine if thin lines or small black text is blurred (printing speed is slower).

— MG Peel Mode which sets the printer to use peel off ribbon in the magnetic

stripe area (if installed).

— Standby Mode which pauses the card after printing and before transferring

the card to the laminator.

— Back Side Cooling which pauses the card to cool it when printing on both sides

of the card.

• Controls for viewing or changing magnetic stripe settings.

Heating Yellow The printer is adjusting the heat roller temperature.

Card Loading

Card Transporting

Contact IC Encoding

Non-Contact IC

Encoding

MG Encoding

Printing

Retransfer

Yellow The printer is issuing cards. The operating status during

card issuing is indicated. When the card is issued, the

printer goes into Ready state.

Power Saving Yellow The printer is in power save mode. To end Power

Saving, press the Reset key on the printer and then

press the Enter key to initialize the printer.

Error Red

See

“Status monitor messages” on page 41.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 108 109

Comentários a estes Manuais

Sem comentários

DataCard LM200 Guia do Utilizador Página 40

Comentários a estes Manuais