DataCard LM200 Guia do Utilizador descarregar pdf (Página 87)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 81

attached to the laminate film. Pull out the cartridge slowly to avoid

dropping the laminate film from the cartridge. If the cartridge cannot

be removed, call for service.

4 Remove the jog dial from the card printer and attach it to the jog dial

insertion slot.

5 Turn the jog dial counter-

clockwise to discharge the

card from the card outlet.

6 Inspect the cartridge:

— If the material on the cartridge is in

one piece:

— Turn the bottom side cartridge

take-up knob counter-clockwise

until all damaged material is

wound neatly on the take-up

spool.

— Turn the top side cartridge take-

up knob clockwise until all the

damaged material is wound

neatly on the take-up spool.

— If the material is split or broken:

— Trim the ends of the broken

portions evenly.

— Align the end of the supply

material with the take-up spool

and apply tape to secure.

— Turn the material onto the

take-up spool until the mended

portion is wound two or three

turns.

7 Replace the loaded laminator

cartridge in the printer until it clicks

into position.

8 Close the laminator door. The laminator re-initializes automatically.

Supp ly Roll

Take-up Spool

Tape

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 108 109

Sem comentários

DataCard LM200 Guia do Utilizador Página 87